Click here to learn about Electronic Throttle Controls and how we develop cruise control systems for them.
Cruise in comfort! With the ComfortSeat Lumbar Support System, you can set the amount of lower back muscle support you need for your individual comfort while driving. Tucked away inside the driver or passenger seat, the Lumbar Support System provides the precise amount of extra lumbar support to your lower back, decreasing lumbar strain at your command. With just the touch of a finger, the seat or console-mounted switch activates a pneumatic motor filling the bladder within the seat. Make every drive a comfortable drive.
The ComfortSeat Lumbar Support Systems are designed to be universal, however, prior to installing the unit, you'll want to inspect the construction of your seat to determine whether or not you will need a front-mount or rear-mount interior bladder. Front-mount units are installed between the inner foam and outer material of your seat, while rear-mount bladders are used in situations where your seat's exterior material is bonded (glued or stitched) to the supporting inner foam material.
Download our 2010 ComfortSeat brochure by clicking here.
Q: What applications are covered by part number 250-1752?
A: ComfortSeat lumbar support 250-1752 was designed specifically for Toyota vehicles and includes an air bladder to fit Toyota seats.
Q: What is the difference between a "front mount" and a "rear mount" ComfortSeat lumbar support?
A: A "front mount" lumbar support is designed to be installed on the front side of the seat between its upholstery and inner foam almost directly against the driver or passenger's lower back. A "rear mount" lumbar support mounts to the backside of the seat between its upholstery and inner foam and provides support by pushing the inner foam forward.
Q: Is the ComfortSeat lumbar support adjustable?
A: Yes. The lumbar support air bladder can be be quietly inflated or deflated to adjust to the driver or passenger's preference.
Q: Can I install the ComfortSeat lumbar support on seats covered in leather?
A: Yes. The ComfortSeat lumbar support can be used on both cloth and leather seats.
Q: Can I combine a ComfortSeat lumbar support system with a ComfortHeat seat heating system?
A: Yes! Seat heaters are the perfect addition to a pneumatic lumbar support from Rostra, but a rear-mount lumbar bladder system, part number 250-1453, is required.
Q: How long does it take to install a Rostra ComfortSeat lumbar support system?
A: A ComfortSeat lumbar support is a universal application and is designed to be easy to install. Estimated installation time is 1 hour.
Q: Am I required to remove the seat from the vehicle during installation?
A: No. The ComfortSeat lumbar support can be installed without removing the seat by simply lifting the seat back material.
Q: Will I have to cut the upholstery during installation of a ComfortSeat lumbar support system?
A: No. Cutting the vehicle's upholstery or stitching is not required when installing a ComfortSeat lumbar support system.
Q: How big is the pneumatic pump included with a ComfortSeat lumbar support system?
A: Each ComfortSeat lumbar support system listed above includes a pump assembly that measures 10" (L) x 6.5" (W) x 1.5" (H).
Q: What are the dimensions of the ComfortSeat lumbar support air bladder that mounts within the seat?
A: The dimensions of each lumbar support air bladder are as follows:
Q: What size hole will I need to make to accommodate the control switch included with the ComfortSeat lumbar support system?
A: The included control switch requires 1/2" x 1-3/8" in either the center console or a seat side panel.
Download a copy of Rostra's 3 Year/36,000 Mile warranty registration card by clicking here.
© 2014 Rostra Precision Controls, Inc. | Phone: (800) 782-3379 | Fax: (910) 276-1354 | 2519 Dana Dr. | Laurinburg, NC 28352